December, 2018 | Arduino Tricks
Monthly Archives

December 2018

Arduino

Arduino Clap Switch

December 11, 2018



The sound created by applause is detected by associate degree electret mike connected to at least one of the Arduino analog input pins.

Arduino-Clap-Switch-Project

The primary time that the clap is detected by the Arduino, associate degree LED are going to be switched on. The second time that a clap is detected the LED are going to be transitioned. during this project, we tend to area unit planning to build Clapper circuit exploitation the idea of ADC in ARDUINO UNO. we tend to area unit planning to use a MIC and Uno to sense the sound and trigger a response. This put on Clap OFF switches primarily activates or OFF the device, by exploitation the clap sound, like a switch.

 

How to Bild a Club Switch :

The project originated from the “emergency”, that|during which I found myself for a few time and which seemed like this you wish to travel into the bed at nighttime, however initial you want to activate the sunshine of the chamber to be ready to notice the switch of the side lamp.

Arduino-Clap-Switch-Project-Circuit-Diagram

Then you switched on the side lamp and run to the chamber’s door once more to show off the bedroom lightweight.



You already notice the chamber lightweight is admittedly simply a method to associate degree finish.

Now, once getting into the chamber, I will directly activate the side lamp victimization twin applause

So save me the unneeded thanks to the bed and back once more to the door to show off the chamber lightweight.

That may sound sort of a hard laziness and that I will already see the primary of you throw your hands up in despair, however it’s here primarily to the tinkering that warms my nerd’s heart.

As clever laptop scientists and hobbyists, one feels like their relentless drive to optimize the method “light on” so was born the subsequent fine-tuning on my side lamp.

Required Parts :

Arduino-Clap-Switch-Project-Parts

  1. Arduino Uno board [ Purchase Arduino Uno Board ]
  2. Project Board
  3. Connecting Cable
  4. Electronic Microphone
  5. Resistor – 330ohm
  6. Resistor – 100kohm
  7. Resistir – 1kohm
  8. Capacitor 100mF
  9. LED Light



SOURCE CODE